Two tealight holders

with crystal pendants

 

      

Two tealight holders with crystal pendants
Available as a kit in the web shop with order number 5 (white) and K 6 (red).
You also need jewelry glue and various pliers.

Components:

General: 
After each step using glue, let the project dry thoroughly (at least two hours).

Glue B in A.

Slide D on the tube C, apply glue to the bottom edge of D
and to the bottom part of the tube.
Slide the tube in B and make sure that the tube does not protrude at the bottom
but is flush with the edge of B.
Make sure the tube is vertical.

Glue parts E, F, G to the tube as shown.
Use little glue and make sure that the parts form a straight line.

Bend the petals of K a little bit downwards with a pair of pliers.
This will make the pendants hang properly in the points of the petals.

Bend the pins between the petals of K outwards.
Try whether the cap H fits K properly.

Make the pendants as follows.
Slide 3 beads on a pin and bend a loop on the pin.
In the “Technique” section of this website you can see how to make these loops.
Of course you can do this your own way.
It requires 6 pendants per tealight, so 12 in total.
Attach the pendants to ornament K and glue K to the tube C.

Finally glue the cap H to the tube.

   

Available as a kit in the web shop with order number 5 (white) and K 6 (red).