Two Cake Stands

 

Two cake stands
The cake stands are 20 mm and 14 mm high and have a diameter of 24 mm.
Available as a kit in the web shop with order number K11.
You also need jewelry glue and needle nose pliers.
The kit does not contain any pastries.

Components:

General: 
After each step using glue, let the project dry thoroughly (at least two hours).

Glue B in A (2x).

Slide D on the tube C, apply glue to the bottom edge of D
and to the bottom part of the tube.
Slide the tube in B and make sure that the tube does not protrude at the bottom
but is flush with the edge of B.
Make sure the tube is vertical.
Repeat this for the second cake stand.

Glue parts E, F, G, to the high tube as shown and parts F, G to the low tube.
The pin of G slides into the tube and the flat side of G
is glued to the edge of F.
Make sure that the parts form a straight line.

Bend the points of H down with a pair of needle nose pliers.

Finally glue H to the base.

Available as a kit in the web shop with order number K11.
The kit does not contain any pastries.