Christmas Wreath

 

Required materials:
ornaments FL430, DV730 and FL286,
30 cm red silk ribbon 2mm wide, thin green wire or florist wire,
holly leaves and holly berries, tacky glue, scissors, side cutting pliers, file.

Tie the little bell to the middle of a piece of red silk ribbon about 20 cm long.

Thread the two ends of the ribbon to each side through the holes of
the inner
circle of ornament FL430. Make sure the bell keeps hanging loose.
To make the threading easier put some tacky glue on the outer ends of the ribbon
and give it a twist. When you have reached the middle below the bell
put the ribbons backwards through a holeĀ  of Fl 430: see photo.

Cut a buckle of ornament FL286 with the cutting pliers.
File the edge smooth with the file if necessary.

Put the buckle on the two ribbons and put some tacky glue on the back of
the buckle to make it stick. Cut the ribbons slantwise to the desired length.
Make a little loop with a piece of red ribbon and attach it to the top of FL430.

Attach little pieces of green wire to FL430 by putting the wire
through the holes of FL430 and bending it resembling little twigs.
Glue holly leaves and holly berries to the wire.

Have fun with this workshop!