Cake Stand with crystal pendants

 

Cake Stand with crystal pendants
The cake stand is 20 mm high and has a diameter of 24 mm.
Available as a kit in the web shop with order number K12.
You also need jewelry glue and various pliers.
The kit does not contain any cake.

Components:

General:
After each step using glue, let the project dry thoroughly (at least two hours).

Glue B in A.

Slide D on the tube C, apply glue to the bottom edge of D
and to the bottom part of the tube.
Slide the tube in B and make sure that the tube does not protrude at the bottom
but is flush with the edge of B.
Make sure the tube is vertical.

Glue parts E, F, G, to the tube as shown.
The pin of G slides into the tube and the flat side of G
is glued to the edge of F.
Make sure that the parts form a straight line.

​Bend the points of H down with a pair of needle nose pliers.

Make the pendants as follows.

Slide 1 bicone bead and 2 round beads on a pin and bend a loop on the pin.
In the “Technique” section of this website you can see how to make these loops.
Of course you can do this your own way.
Make 14 pendants in total and attach the pendants to the bended points of H.

Finally glue H to the base.

Available as a kit in the web shop with order number K12.
The kit does not contain any cake.