Wall Sconce W039

 

You can order a full set of parts to make this wall sconce
in the webshop with order number W039.

Required materials from left to right:
FL400, FL232, KR694, FL451, FL261, OR037 (10x), DV771 (10x), OV900-W

Required tools: round pointed file, combination pliers, ruler, jewel cement,
piece of styrofoam, cocktail sticks, clothes peg or clip.

Bend the arm FL400 with the combination pliers in a straight angle (90º).
Do this at a distance of 15mm of one end of FL400 including the ring of FL400.

File the ring of the short piece of FL400 and the center hole of FL261
a little bit wider to make KR694 fit. Do not glue this yet.

Attach the pendants (OR037) to the holes in the edge of FL261 using
the open rings (DV771).
Make sure the “nice” side of the pendants is showing on the outside.

Place KR694 on a cocktail stick, apply a little glue on the edge of KR694 and
put FL262 on top of this. Apply a little glue on the ring of the short arm of FL400
and put this also on top of KR694 as is to be seen in the photo above.
Make sure the arm of FL400 is positioned between two pendants.
Let it dry thoroughly.

Glue the candle cup FL451 in KR694 and glue the wall plate FL232 to FL400.
Clamp it with a clothes peg or a clip and let it dry thoroughly.
Cut off the candle to the desired length (20mm in the example) and glue it in FL451.

You can order a full set of parts to make this wall sconce
in the webshop with order number W039.