Wall Sconce W036

 

You can order a full set of parts to make this lighted wall sconce
in the webshop with order number W036.

Required materials: see required materials W035.
The candle is being replaced by the light CK1010-17 and CK1010-12 (12 Volt).
Besides jewel cement you also need superglue (gel).

Follow the instruction of the not-lighted wall sconce W035 until you reach
the positioning of the candle.

Cut off the metal pins of CK1010-12 to make it fit into the candle socket (CK1010-17).
Don’t cut off too much at once but try piece by piece until the bulb fits nicely
into the socket.
Glue the candle socket in the candle holder FL451 with a little bit of superglue.
You can glue the wires backwards along the arm of FL400 using some superglue.

The picture above shows two wall sconces with colored pendants.
This is done as follows.

The rings of the pendants KR660 are folded on top of each other.
Bend the top ring open, using your fingernails, and take out the little stone.
Do not bend the pendants open completely but just a little.
Place the stones on a piece of double sided tape and paint them in the color
of your choice using nail polish or glass paint.
You only have to paint one side of the stones.
When the polish is dry, put the stones back in the pendants and
fold the rings back in place.

You can order a full set of parts to make this lighted wall sconce
in the webshop with order number W036.